#2 problem

[Race Grandpa]

The vaccuum distribution block has a hose connected to the cruise control fitting. I do not have cruise control. There is no hose connected to the boost sensor fitting.

The hose from the cruise control fitting goes into a plastic T. The two other hoses connected to the plastic T go to what I think are selenoids.

I thought I should move the hose that is on the cruise control fitting. However, this is a 1/2 inch hose and it looks to big to fit on the boost sensor fitting.

PS: SC is not running.

[Tom @ Fast Forward]

some people, when they do the install, put the fittings in different locations from the diagram. No problem. As you have an unused hole, you have two choices. Get a 1/8" NPT to 1/4" barb and put it in the unused hole and run the hose or cut one of the other hoses and install a tee. Either way will work the same.

[Race Grandpa]

some people, when they do the install, put the fittings in different locations from the diagram. No problem. As you have an unused hole, you have two choices. Get a 1/8" NPT to 1/4" barb and put it in the unused hole and run the hose or cut one of the other hoses and install a tee. Either way will work the same.

Tom, are you saying it is OK as is?

[Tom @ Fast Forward]

The VDB is OK as is but I would move the vacuum line for the bypass valve from the intake manifold to the VDB.