Wire broken on PC-Pro harness

[happychap]

This afternoon I was about to plug my PC Pro back into the ECU and I noticed that there is a wire broken on the ECU side of the harness. It's broken right at the pin, Anyone know how to remove the pin so I can resolder it?

[Tom @ Fast Forward]

I don't. Sorry. One of the white harness wires?

[happychap]

Yes. From looking at a pin out diagram it's a power ground wire.

[Tom @ Fast Forward]

All I can say is send it to me and I'll replace the harness.

[happychap]

Thanks for the offer Tom. I managed to find a flap that opens along the back of the connector, This revealed enough of the pin that I was able to solder another piece of wire to that and then connected that to the broken wire. I'm hoping that will keep any tension of the solder joint. I have it back in the car and a quick spin around the block didn't reveal any problems.

[Tom @ Fast Forward]

Glad it worked out for you. Any idea how it broke? Shouldn't be any tension on it.

[happychap]

It was broke right at the pin, all I can think is it was crimped a little too aggressively and the wire finally broke.

[Tom @ Fast Forward]

Good thing you spotted it.