close to CS!

[imarcr2]

Hello All,

I am getting close to starting up for the first time, but I could use a bit of help. I would like to see a pic of how you routed all that mess of wiring at the front passenger side of the cam cover. Also a pic of the routing of the coolant line that is supplied in the kit(it goes to the thermostat and is a Mazda brand part)

Thanks All


Bill

[FormerDatsun510Man]

Here are a couple shots of mine. The trick is to remove the stock brackets to allows the wiring to be tied better out of the way. Ignore the blue breather filter. I was testing it out and found it really messes up the idle and causes the IAC to honk... the standard hose with restrictor that we include in the kit is the way to go there.

I tied the hose that goes to the thermostat using a bracket as you can see in the pic. You will also notice that I moved the grounds to the front left bolt on the valve cover. They used to be on that bracket that was bolted up around there but I found would get in the way. Just make sure you clean the valve cover and bolt well if you do it that way to ensure a good ground. I actually added a ground cable to it.

Bill

[oldtimer02]

Here is what I did. The tie wraps with the screw loops works great!