gerryBbad
08-26-2010, 12:04 PM
Hello everyone. I've just purchased the pc pro powercard along with the timing unit and have just a few questions. I'm running a hotside M-45 by Jackson Racing, plus other mods. Right now I'm using the 62.5 pully so I think I'm close to 6.5 psi.
Since I bought the cards from Track Dog Racing I'm assuming the setup is a bit different from the cards sold by FF. Instead of having the red/blue mode I have the following. Green, yellow, red then, green/blue, yellow/blue.
I have the green/blue set to 6 1/2, (I think this setting shifts the fuel based on load,rpm and boost?) At WOT in 2nd from 2000rpm up to about 5500 my wideband shows 12.5 to 13. Should I keep the green/blue setting where it is and adjust the first three settings now? From what I've read it looks like I should be closer to 12 or even 11.5?
Also, I'm running 93 octane. So as far as timing, should I keep the green mode at 0 and between 2 and 3 for the yellow mode?
Since I bought the cards from Track Dog Racing I'm assuming the setup is a bit different from the cards sold by FF. Instead of having the red/blue mode I have the following. Green, yellow, red then, green/blue, yellow/blue.
I have the green/blue set to 6 1/2, (I think this setting shifts the fuel based on load,rpm and boost?) At WOT in 2nd from 2000rpm up to about 5500 my wideband shows 12.5 to 13. Should I keep the green/blue setting where it is and adjust the first three settings now? From what I've read it looks like I should be closer to 12 or even 11.5?
Also, I'm running 93 octane. So as far as timing, should I keep the green mode at 0 and between 2 and 3 for the yellow mode?