Where did you mount your PC Pro

[oe_tuner]

Just getting ready to install my new Coldside kit and I was wondering where eveyone is mounting their PC Pro.
I have a 95 with the ECU behind the seat.
I was thinking if there is enough harness in Tom's adapter that I would mount them in the Center Console.

[Tom @ Fast Forward]

Shawn,

Ken would be the only pre-99 with a PC-Pro. You and Brian are the first with two PC-Pros.

The 99+ are by the driver's knee and fit up in the fuse box.

[bogey]

I cut a slot in the carpet above the engine computer behind the passenger seat and slide the control head through. It lays flat on the carpet and is accessable form the drivers seat when you flip the seat forward. I cannot see why I would need to access it all the time once I get it set where I want it.

I have considered extending the wires and laying between the pass seat and tranny tunnel, but I don't think I need to.

KEN

[Tom @ Fast Forward]

It is basically set it and forget it. Only time you should need to adjust it s if you make a minor change like swapping the 105mm pulley for a 120mm. :)