Installing the PC PRO

[ThomS]

Tom this might be a dumb question but here it goes any way .
Do you have instructions for taking out the power card and installing the PC PRO? Instruction like you had for the SC install or is so easy that they are not needed.

[Tom @ Fast Forward]

Dosconnect the 6 wires from the old JRPC. They are simply plug-in.
Disconnect the three connectors from the ECU. On the side of each connector is a place to push. Do not just pull on the wires. You will see where to push when you have the PC-Pro/Harness in your hand. The connectors are identical.
Plug the car harness into the PC-Pro harness.
Plug the PC-Pro harness into the ECU.
Slide the two PC-Pros into the fues box area face up.
Connect the Vacuum/Boost tube from the JRPC to the new PC-Pro connector.
Insert Key.
Drive.