PC-Pro Default from FFS

[liddown]

I have looked but I cannot find what the default settings for an 01+ PC-Pro for both ofthe cards. Pretty sure I am flush with ping in the upper RPM's so I just wanted to run through the settings to make sure I am starting at the right FFS default......

So anyone got the settings? or any 01+ ColdSides that are running good care to share your settings?

Thanks!

[chuckerants]

I have looked but I cannot find what the default settings for an 01+ PC-Pro for both ofthe cards. Pretty sure I am flush with ping in the upper RPM's so I just wanted to run through the settings to make sure I am starting at the right FFS default......

So anyone got the settings? or any 01+ ColdSides that are running good care to share your settings?

Thanks!

What pulley are you running?

Have you had a chance to get on a dyno? How about a WB?

[liddown]

I am running the standard 105 that comes with the kit.. I have had to cancel my dyno time due to a throttle problem I posted about in the 01/05 section. I have plans to get there, just need to get my butterfly issues worked out. No WB as of yet. Guess that is next..... I was just looking to make sure that the cards were starting where they should be.....

[Tom @ Fast Forward]

The defaults are green, yellow and red at 1 and yel/blu and red/blu at 4. The e-cool card should have grn/blu at 4.

What fuel are you running? Could be carbon on the pistons. 01-05 are prone to do that more than the other years. Cats can also cause that.

[liddown]

Thanks again Tom... I am running a high flow FM midpipe with the built-in Cat. Gas Minnesota 91 oh yeah! Once I get the throttle fixed I will dump some 100 into it and see if that makes a difference... I will also try the seafoam treatment... Each winter the car gets a seafoam bath before going to sleep for the long winter, however I have not run it directly into the vacuum line before, just through the fuel system... I will also check the tops of the pistons to see if they shine or if they are black holes....

[Scuba Steve]

Thanks again Tom... I am running a high flow FM midpipe with the built-in Cat. Gas Minnesota 91 oh yeah!

I get 92 Octane all the time in the metro area. I am only stuck with 91 on road trips.